Domed Decal (also doming or 3D resin label): a full-color printed adhesive label finished with a clear polyurethane resin that cures into a raised dome over the artwork. The result is a lens-like gloss surface with real physical depth — saturated color sealed against scratches, moisture, and UV fading. Color renders as a full-color process blend that comes close to brand-color references but does not match exact spot inks.

Domed Decal (also doming or 3D resin label): a full-color printed adhesive label finished with a clear polyurethane resin that cures into a raised dome over the artwork. The result is a lens-like gloss surface with real physical depth — saturated color sealed against scratches, moisture, and UV fading. Color renders as a full-color process blend that comes close to brand-color references but does not match exact spot inks.

Full-color transfer heat-applies a printed film directly onto the item, bonding it as a thin, smooth surface layer. It reproduces photographic imagery, multi-color artwork, and continuous gradients — capabilities solid spot-color methods cannot match. The finished mark reads as a flat, slightly filmic layer with a subtle sheen at the surface boundary; its strength is color complexity, tonal shading, and fine detail.

Pad printing (tampography) transfers ink from a silicone pad onto the item, flexing into curves, angles, and recessed areas flat application can't follow. The result is a thin, nearly flush ink layer with well-defined edges — each color prints as an opaque spot-ink solid, holding evenly on contoured or darker surfaces; cured ink resists everyday wear.

Laser engraving uses a focused beam to etch your design directly into the surface, leaving a permanent, recessed mark with clean, sharp edges that hold fine lines and small text. The result carries no separate ink: it reads in the substrate's own tone — a lighter shade on metal, a darker burn on wood — with a depth you can feel and a mark that resists fading, wear, and scratching.