Laser engraving uses a focused beam to etch your design directly into the surface, leaving a permanent, recessed mark with clean, sharp edges that hold fine lines and small text. The result carries no separate ink: it reads in the substrate's own tone — a lighter shade on metal, a darker burn on wood — with a depth you can feel and a mark that resists fading, wear, and scratching.

D4 prints CMYK artwork directly onto the item and finishes it with a clear protective coat, giving the full-color image a subtle raised, tactile dimension. It reproduces photographs, gradients, and multi-color artwork with fine detail. Spot colors are not available on this process — color is a full-color blend that comes close to brand references rather than matching exact spot inks.

Laser engraving uses a focused beam to etch your design directly into the surface, leaving a permanent, recessed mark with clean, sharp edges that hold fine lines and small text. The result carries no separate ink: it reads in the substrate's own tone — a lighter shade on metal, a darker burn on wood — with a depth you can feel and a mark that resists fading, wear, and scratching.

Four-color-process heat transfer prints your design in CMYK onto a release film, then bonds it to the garment under heat and pressure. It reproduces photographs, gradients, and many-color artwork with continuous-tone fidelity that solid spot inks cannot match. The finished mark reads as a smooth, low-profile layer at the surface; color is built from blended process inks, landing close to brand references rather than as exact spot solids.

Screen printing presses ink through a fine mesh stencil, laying down each color as a separate pass. Each color lays down as its own premixed spot ink, printing solid and consistent across the run. The applied mark is flat and opaque, sitting on top of the material with crisp edges; on heavy coverage, you can feel a slight raised texture where ink builds up. The cured ink is durable and holds up to repeated handling and washing.

Foil stamping (hot stamping) presses a thin metallic foil onto the surface with a heated metal die, bonding it where the die makes contact and leaving a shallow pressed-in impression. The mark reads as a single reflective metallic tone: it throws light at some angles and darkens to an outline of itself at others, giving the logo depth against the base. Solid shapes and bold lettering hold cleanly; very fine lines and small text can soften as the foil seats under pressure.

The 360 wrap prints full-color artwork around the entire circumference of the item in one continuous pass. Photographs, gradients, patterns, and multi-color designs carry seamlessly around the body, reading as a flat, high-resolution image. Color is a full-color process blend that comes close to brand references rather than matching exact spot inks.

A 360 wrap engraving rotates the product under the laser so artwork, patterns, or repeating designs run continuously around the body. Like all laser engraving, the mark is colorless — the finish beneath is revealed in a precise, permanent etch that will not wear or wash away. It suits designs made to be seen from every angle.

Four-color-process heat transfer prints your design in CMYK onto a release film, then bonds it to the garment under heat and pressure. It reproduces photographs, gradients, and many-color artwork with continuous-tone fidelity that solid spot inks cannot match. The finished mark reads as a smooth, low-profile layer at the surface; color is built from blended process inks, landing close to brand references rather than as exact spot solids.